Stepping Stone Mold Concrete Block Maker House Decoration Mold for Garden Pathway Yard Lawn

About this item

• Feature: 1. Simple Operation: This unique mold is easy to use. You simply pour the cement or concrete into the mold and let it cool, then release the mold to get a beautiful shape. 2. Ideal Decoration: Using these molds, you can create beautiful concrete finishes for your home decor, perfect for garden paths or terraces. 3. Strong Material: The stepping stone mold is made of sturdy and durable ABS material to ensure maximum strength and durability, so it can be used for a long time. 4. Novice Friendly: No special skills required, even an inexperienced person can create a beautiful pathway decoration, not much complex steps needed. 5. No Burden: ABS material makes the concrete block mold have a light weight, will not increase the burden or cause additional energy waste for carrying with. Specification: Item Type: Stepping Stone Mold Material: ABS Color: As Picture Shown Application: for Garden, Pathway, Yard, Lawn Bottom: 38x28cm/15.0x11.0in Top: 33.5x25cm/13.2x9.8in Height: 4cm/1.6in Gross Weight: Approx.412g/14.5oz. Package List: 1 x Stepping Stone Mold Note: Prepare molds: Before mixing concrete, make sure molds are clean and free of dirt. If used before, clean with soapy water. Just brush a little light vegetable oil or release on the form. Release agent is recommended, but not required. Not using a release agent makes it harder to release the stone, and you need to be more careful about damaging the mold. But too much release agent can cause bubbles on the surface.Mixed concrete:Always wear appropriate safety equipment (rubber gloves and particulate mask) when mixing concrete.Mixing can be done by hand in a bucket using an appropriate concrete mixer, a cart with a concrete hoe, or a shovel. It s very important to take the time to mix everything thoroughly.Tip: Adding coloring to the concrete will make the stepping stones look more natural and beautiful.Filling mold:Fill the bottom of the mold with concrete and pat vigorously to remove bubbles. Then fill the mold completely to the top and smooth the top surface by hand so that the concrete is smooth and even. Finish the mold by tapping and shaking to drain as many bubbles as possible. Curing and demoulding:When the mold is full, place the mold on a horizontal table. Cover with plastic film and wait less than 24 hours to cure. Plastic sheeting covered with concrete will help maintain humidity in the interior, like a greenhouse, which will minimize surface cracking. After the stone solidifies, it is then carefully pulled up gradually in all directions until it pops out.